Winsmart Electronic Co.,Ltd
Call us +86 13829839112 Focusing on innovation for PCB automation!
Add to Cart
1.8KW PCB Depaneling Equipment PCBA Router Win 10 Operation System
Precision PCBA Router Machine Win 10 Operation System PCB Depaneler
PCB Depaneler Introduction:
It is used for special shaped and irregular PCB board, stamp hole board, multi-point board depaneling.
It mainly uses the equipment that the milling cutter operates at high speed to separate the multi connected PCB according to the pre programmed path, instead of the cutting defects of manual breaking or V-CUT or push. It has high and accurate cutting precision, long service life, good cutting quality, no dust, no burr, low stress, safety and simplicity, improves the product quality and reduces the scrap rate. It is mainly used to segment special-shaped and irregular PCB board, stamp orifice board and multi-point board. The cutting stress is smaller, so as to prevent chips such as PCBA board capacitor from being damaged in the cutting process; Avoid tin crack and component damage caused by manual folding.
PCB Depaneler Features:
1. Dual workbench, with the maximum speed of 100mm / s and the positioning speed of 500mm / s.
2. It can be cut continuously without interruption during loading and unloading.
3. The high-quality shaft system can accelerate and decelerate the system quickly, reduce the synchronization time, reduce the travel productivity, and adhere to high precision.
4. Use high-quality hardware to ensure high rigidity and high functionality.
5. Cover all lead screws to prevent dust from entering, and then move the service life and function of the rotating shaft.
6. Germany spindle is used to ensure precise cutting.
7. It comes with vacuum cleaner for dust free workshop.
PCB Depaneler Specification:
| Router Machine | |
| X/Y Cutting Speed | 0 ~100mm/s |
| Repeatability precision | ± 0.01mm |
| X/Y1/Y2/Z control mode | Industrial IPC and PC |
| X/Y1/Y2/Z driven mode | AC Servo Motor |
| Operation and data storage | PC |
| Cutting Precision | ± 0.05mm |
| Spindle Speed | 60000rpm(Germany KKAVO) |
| Power Supply | 220V/110V |
| Air Pressure | 4.5kg/cm 2 |
| Power Rate | 1.8KW |
| Vacuum Cleaner | |
| Mode | Up or Bottom |
| Power Supply | 380V |
| Up Cleaner Dimension | L650*W400*H1350mm |
| Bottom Cleaner Dimension | L665*W635*H1650mm |
PCB Depaneler Operation Steps:
1. Check whether the equipment is powered on normally and confirm that the equipment has been reset and waiting for operation.
2. The operator shall determine the direction and positive and negative directions of the PCB board, place the PCB board on the special fixture, press it gently with the palm of his hand, confirm that the PCB board has been placed, put down the gland and ensure that the PCB board has been tightly covered.
3. Use the visual camera to adjust the programmed cutting path and confirm to save.
4. Press the start button, the machine starts to work, the vacuum cleaner, spindle, electrostatic removal, etc. will also start automatically, and the milling cutter divides boards according to the programmed cutting path.
5. Complete the whole assembly and PCB depaneling, the workbench will exit automatically, open the gland, make sure that the separated PCB board is not damaged, manually remove the product, replace the new PCB board, cover the gland, and click the start button to separate.
6. Repeat step 4.5 until all products are cut.